Product Parameters
|
Model |
12V 356Ah |
| Rated Voltage |
12.8V |
|
Nominal Capacity |
356Ah |
| Energy | 4.556kWh |
| Size(mm) |
390*202*278mm
|
| BMS Protection Function |
Over charge protection, Over discharge protection, Temperature protection, Balanced function |
| Charge-end-off Voltage |
14.6V |
| Max. Continuous Charging Current |
200A |
|
Max. Continuous Discharging Current |
200A |
|
Peak Discharge Current |
400A(3S) |
| Charge Temperature |
0-55℃ |
| Discharge Temperature |
-20-60℃ |
| Storage Temperature |
Within 2 months:-20℃~40℃,Within 6 months:-10-35℃ |
|
Optional |
CAN/RS485/Heating Function,Bluetooth (standard) |
Features
1. One case, 4556Wh — the two-battery bank, collapsed into one. At 356Ah, this pack does the work of a pair of 200Ah batteries without the extra cabling, fusing and balancing headaches. Fewer connections means fewer things to check, and one BMS governs the whole bank.
2. 8000+ cycles from EVE Grade-A cells. The matched Grade-A LiFePO4 cells inside are rated for more than 8000 charge cycles. Run it every day and it still has years left after a decade; on a weekend rig, it will probably outlive the van itself.
3. 200A in, 200A out. Charge at up to 200A from a large solar array or a DC-DC charger, and pull 200A continuous on the output side — enough for a 2000W inverter, rooftop air conditioning and a compressor fridge running at once. For bigger banks, up to 4 packs can be wired in parallel.
4. It fits the box you already have. The 390 × 202 × 278 mm case matches the standard battery compartments in most motorhomes, caravans and boats. No new brackets, no relocation, no cutting — unbolt the lead-acid, bolt this in, and the system charges on the same 14.6V profile.
5. Every charge source works as-is. Solar controller, vehicle alternator, generator, shore power through an AC charger — all run on the standard 12.8V charging profile with no reconfiguration or extra gear.
6. Bluetooth monitoring as standard. Open the app and read state of charge, voltage, current, cycle count and fault codes on the spot. When a customer rings asking "is it charging?", the answer takes ten seconds instead of a multimeter.
7. A BMS that handles the things you forget. Over-charge, over-discharge, over-current, short circuit, high and low temperature — protection stays on between trips, including -20°C low-temperature handling for winter storage and cold-weather starts. At the same usable energy, the pack weighs a fraction of the lead-acid bank it replaces, and that saved weight goes back into water, fuel and payload.
Applications
Motorhome and caravan house battery 4556Wh runs the fridge, lighting, water pump and inverter loads for days between charges — and the standard case means it swaps straight into the existing battery compartment.
Campervan conversions (VW / Sprinter / Transit class) One pack covers the whole electrical system of a short-wheelbase conversion, leaving room in the garage for bikes, boards and water.
Marine and onboard power 12.8V LiFePO4 in a sealed case that tolerates the bilge, the locker floor and the occasional hose-down, with 200A available for windlass and inverter loads.
Off-grid solar and backup power 4556Wh per unit, four units in parallel — 18kWh-class storage built from standard, off-the-shelf packs that any technician can service.
FAQ
A: Sample orders start at 1 set, with small batches of 50 sets and large batches of 500 sets or more. We understand the needs of partners of all sizes.
A: We accept payment for samples, and the sample fee will be refunded upon placement of a bulk order. Sample lead time is 7–10 days
A: Standard dimension and terminals support direct replacement, no complicated wiring changes required.
A: Supports multi-unit parallel connection to upgrade total capacity, matching various RV power needs.
A: Built-in BMS temperature protection ensures stable operation in hot and cold outdoor environments.
A: Compatible with solar panel, vehicle generator and shore power for flexible daily charging.
A: Durable lithium cells with full safety protection cut maintenance issues and replacement costs.
A: We provide a complete set of certified scanned copies and test report summaries, with UN 38.3 test reports and MSDS documents included for each batch.










